JVC GR-DX28 ユーザーズマニュアル

MasterPage: Advan_Heading0_Right

During recording, a time code is recorded on the tape. 
This code is to confirm the location of the recorded scene 
on the tape during playback. 

* Frames are not displayed during recording.

If recording starts from a blank portion, the time code 
begins counting from “00:00:00” (minute:second:frame). 
If recording starts from the end of a previously recorded 
scene, the time code continues from the last time code 
number.
To perform Random Assemble Editing (

墌 pg. 41 – 44), 

time code is necessary. If during recording a blank 
portion is left partway through the tape, the time code is 
interrupted. When recording is resumed, the time code 
starts counting up again from “00:00:00”. This means the 
camcorder may record the same time codes as those 
existing in a previously recorded scene. To prevent this, 
perform “Recording From The Middle Of A Tape” (see 
below) in the following cases;

● When shooting again after playing back a recorded tape.

● When power shuts off during shooting. 

● When a tape is removed and re-inserted during shooting.

● When shooting using a partially recorded tape. 

● When shooting on a blank portion located partway through 

the tape.

● When shooting again after shooting a scene then opening/

closing the cassette holder cover.

● The time code cannot be reset.

● During fast-forwarding and rewinding, the time code 

indication does not move smoothly.

● The time code is displayed only when “TIME CODE” is set 

to “ON”. (

1) Play back a tape or use Blank Search (

墌 pg. 18) to 

find the spot at which you want to start recording, then 
engage the Still Playback mode. (

2) Set the Power Switch to “A” or “M” while pressing 
down the Lock Button located on the switch, then start 
recording.

Load a cassette. (

Set the VIDEO/MEMORY Switch to “VIDEO”. 

(GR-DX97/77/67only)

Set the Power Switch to “PLAY” while pressing down 

the Lock Button located on the switch.

To start playback, press 4/9.

To stop playback, press 8.

● During Stop mode, press 3 to rewind, or 5 to fast-

forward the tape.

To control the speaker volume
Press VOL. + to turn up the volume, or VOL. – to turn 
down the volume.

● The playback picture can be viewed in the LCD monitor, 

viewfinder or on a connected TV. (

● If Stop mode continues for 5 minutes when power is 

supplied from a battery, the camcorder shuts off 
automatically. To turn on again, set the Power Switch to 
“OFF”, then to “PLAY”.

● When a cable is connected to the AV connector, the sound 

is not heard from the speaker.

Pauses during video playback.
1) Press 4/9 during playback.
2) To resume normal playback, press 4/9 again.

● If still playback continues for more than about 3 minutes, 

the camcorder’s Stop mode is automatically engaged.

4/9

3

8

5

GR-DX97PAL.book  Page 17  Tuesday, January 6, 2004  12:44 PM