JVC lt-20da6ssp ユーザーズマニュアル

- 14 -

Step 6: Switching the TV ON/OFF
To switch the TV on
Your TV will switch on by two steps:
1- Connect the power supply cord to the sys-

tem. Then the TV switches itself to stand-

by mode and the power lamp becomes

red located on the front of the TV.

2- To switch on the TV from stand-by mode

either:

Press the

button on the remote control

or on the right side of the TV
or.
press a digit button on the remote control so

that a programme number is selected,
or,
Press

buttons on the right

side of the TV or on the remote control, so that

last switched off programme is selected.
By either ways the TV will switch on and the

power lamp will become green.
To switch the TV off

Press the

button on the remote con-

trol or on the right side of the TV, so the TV

will switch to stand-by mode and the power

lamp will become red.

NOTE: To switch the TV off completely remove

the mains plug from the socket.
Step 7: Initial settings
When the TV is first turned on, it goes into the

initial settings mode. Follow the instructions

on the screen display to make the initial set-

tings.

Note: If the TV does not go into the initial settings mode this

is because your TV has already been turned on for the first

time. (Perform the initial settings with INSTALLATION (

see

page 24

) in the DTV menu and AUTO STORE (Analogue)

(

see page 31

) in the PROGRAM menu.)

Because this is the first time that IDTV has

been used, there are no channels stored in

the memory and below information will be dis-

played on the screen.
1. Press the OK button to start the automatic

search.

35/LVW(PSW\6WDUWDXWRPDWLFVHDUFK

The IDTV will automatically tune to the UHF

transmission channels 21 to 68 looking for

digital terrestrial TV broadcasts and display-

ing the names of channels found. This pro-

cess will take about five minutes. To cancel

searching, you can press MENU button at any

time during the process.
HINT: Depending on the reception conditions

in your particular area, you may find that the

list of channels found includes one or more

repeated names. This is because the receiver

may detect and store some channels, includ-

ing those it cannot receive clearly, from adja-

cent areas alongside the strong channels from

a transmitter nearby. This is not a problem

and the weaker channels can be deleted from

the receiver later, as described in - Edit PR

List on

page 22

2. When the automatic search has finished,

the EDIT PR LIST menu appears.

If you want to, you can now edit the

programme numbers (PR) using the EDIT

PR LIST function. For details, see Edit PR

List on

page 22.

If you do not want to edit programme num-

bers (PR), go to the next step.

3. Press the MENU button.
The EDIT PR LIST menu disappears and the

following message appears.

'R\RXZDQWWRVHDUFKIRU

DQDORJXHFKDQQHOV"

<HV

If you select Yes, Analogue terrestrial broad-

casting AUTOMATIC PROGRAMMING SYSTEM

(A.P.S.) window is displayed.

$XWR3URJUDP

3OHDVH&KHFN$QWHQQD&DEOH

$XWR3URJUDPPLQJ6\VWHP

/DQJXDJH

(QJOLVK

&RXQWU\

2.&DQFHO

01-ENG-20710W-17MB16P-C1897S UK-(LT-20DA6SSP)-(TVAVOK)-IDTV-10042117-5008XXXX.p65

15.06.2006, 17:39