buell s1 lightning '97 マニュアル
7-41
HORN
REMOVAL
1.
Remove ignition coil to detach horn bracket from frame.
See
See
IGNITION COIL, REMOVAL
on
page 7-17
.
2.
See
Remove power wire (6) from spade
connection.
3.
Detach ground wire (4) from horn by removing locknut (1)
(metric) and washer (3).
(metric) and washer (3).
INSTALLATION
1.
Install horn on bracket with ground wire
(4), washer (3) and locknut (1) (metric).
2.
Attach power wire (6).
3.
Install horn and ignition coil. See
IGNITION COIL,
INSTALLATION
on
page 7-17
.
TROUBLESHOOTING
1.
If the horn does not sound or fails to function satisfacto-
rily, check for the following conditions.
rily, check for the following conditions.
a. Discharged
battery.
b.
Loose, frayed or damaged wiring leading to horn ter-
minal.
minal.
2.
If battery has a satisfactory charge and wiring appears to
be in good condition, check for the following.
be in good condition, check for the following.
a.
Poor ground to frame through mounting hardware or
ground wire (see Steps 3-5 below).
ground wire (see Steps 3-5 below).
b.
Inoperative horn switch (see Steps 3-5 below).
3.
Remove terminal clips from connections.
4.
Connect a voltmeter as follows.
a.
Positive (+) lead to wire terminal.
b.
Negative (–) lead to ground.
5.
Turn ignition switch to IGN. Depress horn switch. If bat-
tery voltage is present, horn or horn grounding is faulty. If
battery voltage is not present, either horn switch or wiring
to horn is faulty.
tery voltage is present, horn or horn grounding is faulty. If
battery voltage is not present, either horn switch or wiring
to horn is faulty.
a. If horn is faulty, then it must be replaced as an
assembly. The horn is not repairable.
b.
If horn switch is faulty, replace left handlebar switch.
See
See
on
.
Figure 7-42. Horn Assembly
1.
Locknut (metric)
2.
Horn mounting
bracket
bracket
3.
Ground connection
4.
Internal tooth washer
5.
Horn
6.
Power wire
b0081a7x
1
2
3
5
4
6