TP-LINK TL-WR2543ND ユーザーズマニュアル

 

- 23 - 

Step 2:  The Wi-Fi Protected Setup LED flashes for two minutes during the Wi-Fi Protected 

Setup process.   

Step 3:  When the WPS LED is on, the client device has successfully connected to the Router.   

Step 4:  Refer back to your client device or its documentation for further instructions.   

)

 

1)  The WPS LED on the Router will light green for five minutes if the device has been 

successfully added to the network. 

2)  The WPS function cannot be configured if the Wireless Function of the Router is disabled. 

Please make sure the Wireless Function is enabled before configuring the WPS. 

 

Figure 4-5  the Network menu 

There are three submenus under the Network menu (shown in Figure 4-5): WAN, MAC Clone 
and LAN. Click any of them, and you will be able to configure the corresponding function.   

Choose menu “Network  → WAN”, you can configure the IP parameters of the WAN on the 

screen below. 

1.  If your ISP provides the DHCP service, please choose Dynamic IP type, and the Router will 

automatically get IP parameters from your ISP. You can see the page as follows (Figure