TP-LINK TL-WR2543ND ユーザーズマニュアル

 

- 70 - 

By default, the radio button “All the PCs on the LAN are allowed to access the Router's 

Web-Based Utility” is checked. If you want to allow PCs with specific MAC Addresses to access 

the Setup page of the Router's Web-Based Utility locally from inside the network, check the radio 

button “Only the PCs listed can browse the built-in web pages to perform Administrator 

tasks”, and then enter each MAC Address in a separate field. The format for the MAC Address is 

XX-XX-XX-XX-XX-XX (X is any hexadecimal digit). Only the PCs with MAC address listed can 

use the password to browse the built-in web pages to perform Administrator tasks while all the 

others will be blocked.   

After click the Add button, your PC's MAC Address will be placed in the list above. 

Click the Save button to save your settings.   

)

If your PC is blocked but you want to access the Router again, use a pin to press and hold the 

Reset button (hole) on the back panel for about 5 seconds to reset the Router’s factory defaults 

on the Router’s Web-Based Utility. 

Choose menu “Security  → Remote Management”, and then you can configure the Remote 

Management function in the screen as shown in Figure 4-57. This feature allows you to manage 

your Router from a remote location via the Internet. 

 

Figure 4-57 Remote Management 

¾

 

Web Management Port - Web browser access normally uses the standard HTTP service 
port 80. This Router's default remote management web port number is 80. For greater 
security, you can change the remote management web port to a custom port by entering that 
number in the box provided. Choose a number between 1 and 65534 but do not use the 
number of any common service port.   

¾

 

Remote Management IP Address - This is the current address you will use when accessing 
your Router from the Internet. This function is disabled when the IP address is set to the 
default value of 0.0.0.0. To enable this function change 0.0.0.0 to a valid IP address. If set to 
255.255.255.255, then all the hosts can access the Router from internet.