Epson 2500 ユーザーズマニュアル

EPSON Stylus Scan 2500

9/99

EPSON Stylus Scan 2500

 - 8

The following tips help you get the best results:

❏ Always load the printable side (the whiter and brighter side) 

face up. Some special papers come with a cut corner to help 
you load them correctly.

❏ Load letterhead or preprinted paper so the top of the paper 

feeds into the printer first.

❏ Don’t load paper above the arrow on the left edge guide.

❏ You can load up to 20 sheets of Photo Paper, 

30 transparencies, and 30 Photo Quality Ink Jet Cards. 
For Photo Quality Ink Jet Paper, you can load up to the 
arrow mark on the left edge guide.

❏ Use a support sheet if you find it in the paper package.

❏ Return unused paper to the original package as soon as you 

finish printing.

When you’re low on ink or one of the cartridges is empty, 
you’ll see a message on the LCD status display panel. It’s a 
good idea to keep new cartridges on hand, since you can’t 
print if either ink cartridge is empty.

Caution:
To ensure good results, use genuine EPSON cartridges and do not 
refill them. Other products may cause damage to your printer not 
covered by EPSON’s warranty.

Use these EPSON ink cartridges within six months of 
installing them and before the expiration date on the package:

❏ Black ink cartridge: 

S020189

❏ Color ink cartridge:

S020191

If you need to replace an ink cartridge before you see a 
message (because the ink is too old, for example) follow the 
instructions in “Replacing an Outdated Ink Cartridge” on 
page 9.

You can replace a cartridge whenever you see a message that 
the cartridge is low on ink or empty. (If you press the 

 

R 

cleaning button before you see a message, the EPSON 
Stylus Scan cleans the print head, as described on page 9. 
Follow these steps:

1. Remove the new ink cartridge from its package.

Caution:
You must remove the yellow tape from the top of the cartridge 
or you will permanently damage it. Do not remove the clear 
seal from the bottom of the cartridge, or ink will leak out.

2. Remove only the yellow part of the tape seal on top. Don’t 

pull off the blue portion or try to remove the clear seal 
underneath the cartridge.

Note:
If you have an automatic document feeder, remove it from the 
EPSON Stylus Scan, but don’t disconnect it from the option 
interface.

3. Make sure the EPSON Stylus Scan is turned on and not 

printing. Open the document cover, and then open the 
maintenance cover. The internal cover opens automatically.

4. Press the 

 

R cleaning button and hold it for about three 

seconds until the print head moves left and the 

Operate

 

light begins flashing.

Caution:
Don’t open the clamp or remove a cartridge except to replace it 
with a new one. Once you remove a cartridge, you can’t reuse 
it, even if it contains ink.

Also, never move the print head by hand.

maintenance 
cover

document 
cover

internal 
cover