Epson 2500 ユーザーズマニュアル

EPSON Stylus Scan 2500

9 -

 

EPSON Stylus Scan 2500

9/99

5. Pull up the ink cartridge clamp. The cartridge rises up from 

its holder.

Warning:
If ink gets on your hands, wash them thoroughly with soap and 
water. If ink gets into your eyes, flush them immediately with 
water.

Keep ink cartridges out of the reach of children.

6. Lift the cartridge out of the EPSON Stylus Scan and 

dispose of it carefully.

7. Lower the new ink cartridge into its holder with the label 

facing up and toward the back of the printer. Don’t press 
down on the cartridge.

8. Press down the ink cartridge clamp until it locks in place.

9. If you need to replace the other ink cartridge, repeat the 

preceding steps before going on to step 10.

10. Close the maintenance and document covers, and then 

press the 

 

R cleaning button.

Caution:
Never turn off the printer while the Operate light is flashing, 
unless the printer hasn’t moved or made any noise for more 
than five minutes.

The EPSON Stylus Scan moves the print head and begins 
charging the ink delivery system. The 

Operate

 light flashes 

and the printer makes various sounds. Charging takes about 
60 seconds. When it’s finished, the 

Operate

 light stops 

flashing and stays on.

Even if you don’t see a message that a cartridge is low on ink 
or empty, you may need to replace it if it’s more than six 
months old. If your printouts don’t look as good as they used 
to, try cleaning and aligning the print head first. If print 
quality doesn’t improve, try replacing one or both cartridges.

Follow these steps to replace an ink cartridge before you see a 
message on the LCD status display panel:

1. Prepare your new ink cartridge for installation as described 

in “Removing and Installing Ink Cartridges” on page 8.

2. Make sure the EPSON Stylus Scan is turned on and not 

printing. Then open the document and maintenance 
covers.

3. Press the 

 

E load/eject button and hold it down for about 

three seconds until the print head moves left. The 

Operate

 

light begins flashing.

4. Remove the old ink cartridge and install the new cartridge 

as described in “Removing and Installing Ink Cartridges” 
on page 8. Don’t press the 

 

R cleaning button, however.

5. Close the maintenance and document covers and press the 

 

E load/eject button.

Caution:
To avoid damaging the printer, never move the print head by 
hand. 

The EPSON Stylus Scan moves the print head and begins 
charging the ink delivery system. The 

Operate

 light flashes 

and the printer makes various sounds. Charging takes about 
60 seconds. When it’s finished, the 

Operate

 light stops 

flashing and stays on.

If your printouts are light or have gaps in the image, you may 
need to clean the print head. This unclogs the nozzles so they 
can deliver ink properly.

Cleaning the print head uses ink, so clean it only if print 
quality declines. You can clean the print head using either:

❏ The Head Cleaning utility in your printer software (with 

the printer connected to a local port, not over a network)

❏ The EPSON Stylus Scan’s control panel buttons.

1. Make sure the EPSON Stylus Scan is turned on but not 

printing. Also, make sure that there’s no ink out message on 
the LCD status display panel.