Sharp FO-DC535 ユーザーズマニュアル

Optional Settings

sender’s name entered in Chapter 1 will appear). Press 

 or 

 to 

make the selection and then press 

.

♦

Initial setting: OFF

Setting 25: BEEP LENGTH
This sets the duration of the beep that signals the end of transmission, 

reception, and copying. Press 

 or 

 to select a duration (3 

SECONDS, 1 SECOND, or NO BEEP) and then press 

.

♦

Initial setting: 3 SECONDS

Setting 26: TELEPHONE BILLING CODE
This setting allows you to use Department Codes or direct billing codes for 
telephone billing on a PBX. (Your dealer must first activate Department 
Control or direct billing code entry.) Select ON to turn telephone billing on, or 

OFF to turn it off. Press 

 or 

 to make the selection and then press 

.

♦

Initial setting: OFF

If you selected ON, the BILLING CODE DIAL selection will subsequently 
appear. Select BEFORE if your PBX must receive the billing code before 
dialing a telephone number, or AFTER if it must receive the billing code after 

dialling a telephone number, and then press 

. (Refer to your PBX 

manual or consult your PBX adminstrator for this information.)

Note: If you select AFTER for the BILLING CODE DIAL selection, you must press 

 after dialing if you use 

 .

Setting 27: DEPARTMENT CODE DIGITS
Use this setting if you are using Telephone Billing and need to change the 
number of digits of Department Codes to accord with your PBX’s telephone 

billing system. Enter any number from 

 to 

.

♦

Initial setting: 4