APC ups network management card 2 ap9630 ユーザーズマニュアル

You can use a local computer that connects to the Network Management Card 
through the serial port to access the command line interface.

1. Select a serial port at the local computer, and disable any service that uses 

that port.

2.    Connect the provided serial cable (APC part number 940-0299) to the 

selected port on the computer and to the configuration port at the 
Network Management Card. 

3.    Run a terminal program (such as HyperTerminal

®

) and configure the 

selected port for 9600 bps, 8 data bits, no parity, 1 stop bit, and no flow 
control.

4.    Press 

E

NTER

, repeatedly if necessary, to display the User Name prompt. 

If you are unable to display the User Name prompt, verify the following:
– The serial port is not in use by another application.
– The terminal settings are correct as specified in step 3.
– The correct cable is being used as specified in step 2.

5.    Press the Reset button. The Status LED will flash alternately orange and 

green. Press the Reset button a second time immediately while the LED 
is flashing to reset the user name and password to their defaults 
temporarily.

6.    Press 

E

NTER

, repeatedly if necessary, to display the User Name prompt 

again, then use the default, apc, for the user name and password. (If you 
take longer than 30 seconds to log on after the User Name prompt is 
redisplayed, you must repeat step 5 and log on again.)

7.    At the command line interface, use the following commands to change 

the User Name and Password settings, both of which are now apc:

user -an yourAdministratorName 

user -ap yourAdministratorPassword 

For example, to change the Administrator user name to Admin, type:

user -an Admin 

8.    Type quit or exit to log off, reconnect any serial cable you 

disconnected, and restart any service you disabled.