APC ups network management card 2 ap9630 ユーザーズマニュアル

After you log on at the command line interface, as described in “Local access to 
the command line interface” on page 11 or “Remote access to the command line 
interface” on page 12, you can manually configure network settings.

1.    Contact your network administrator to obtain the IP address, subnet 

mask, and default gateway for the Network Management Card. 

2.    Use these three commands to configure network settings. (Text in italics 

indicates a variable.)

a.tcpip -i yourIPaddress 

b. tcpip -s yourSubnetMask 

c. tcpip -g yourDefaultGateway 

For each variable, type a numeric value that has the format 
xxx.xxx.xxx.xxx

. 

For example, to set a system IP address of 156.205.14.141, type the 
following command and press 

E

NTER

:

tcpip -i 156.205.14.141

3.    Type exit. The Network Management Card restarts to apply the 

changes.