Alliance Laundry Systems sf250pv tilt ユーザーズマニュアル

ページ / 174
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
3
F232101
Safety
Anyone operating or servicing this machine must 
follow the safety rules in this manual. Particular 
attention must be paid to the CAUTIONWARNING
and DANGER blocks which appear throughout the 
manual.
The following warnings are general examples that 
apply to this machine. Warnings specific to a particular 
operation will appear in the manual with the 
discussion of that operation.
Be careful around the open door, 
particularly when loading from a level 
below the door. Impact with door edges 
can cause personal injury.
SW025
CAUTION
Dangerous voltages are present in the 
electrical control box(es) and at the motor 
terminals. Only qualified personnel 
familiar with electrical test procedures, 
test equipment, and safety precautions 
should attempt adjustments and 
troubleshooting. Disconnect power from 
the machine before removing the control 
box cover, and before attempting any 
service procedures.
SW005
WARNING
Death or serious injury can result if 
children become trapped in the machine. 
Do not allow children to play on or around 
this machine. Do not leave children 
unattended while the machine door is 
open.
SW001
DANGER
This machine must be installed, adjusted, 
and serviced by qualified electrical 
maintenance personnel familiar with the 
construction and operation of this type of 
machinery. They must also be familiar 
with the potential hazards involved. 
Failure to observe this warning may result 
in personal injury and/or equipment 
damage, and may void the warranty.
SW004
WARNING
Ensure that the machine is installed on a 
level floor of sufficient strength and that 
the recommended clearances for 
inspection and maintenance are provided. 
Never allow the inspection and 
maintenance space to be blocked.
SW020
CAUTION
Never touch internal or external steam 
pipes, connections, or components. 
These surfaces can be extremely hot and 
will cause severe burns. The steam must 
be turned off and the pipe, connections, 
and components allowed to cool before 
the pipe can be touched.
SW014
WARNING