Ariens sno-thro 924126 st11526dle ユーザーズマニュアル

GB - 21

IMPORTANT: Battery is maintenance-free. Do 
not tamper with or attempt to open battery. 
See Service and Adjustments for charging 
procedures.

Keep battery and its terminals clean.

IMPORTANT: Remove battery from unit 
before cleaning.
Remove corrosion from battery terminals and 
cable connections with a wire brush, then 
wash with a weak baking soda solution. 

After cleaning, apply a thin coat of grease or 
petroleum jelly to terminals and cable ends to 
retard corrosion.

Deflector must stay in selected position while 
throwing snow.

If deflector does not stay in set position: 

1. Tighten nut beneath the control panel to 

increase friction on pressure flange 
(Figure 16).

If deflector does not follow full range of travel:

1. Push deflector remote all the way 

forward.

2. Loosen adjusting nuts on cable support 

bracket.

3. To adjust the deflector lower:

Slide cable down. Tighten bottom nut.

4. To adjust deflector higher: 

Slide cable up. Tighten top nut.

5. Check travel and repeat adjustment as 

necessary.

1. Auger and Shaft
2. Discharge Chute
3. Sprocket/Pinion 

Assembly

4. Axle Shaft

5. Shift Lever Arm
6. Pinion Chain
7. Hex Shaft
8. Shift Link

1

1

6

8

3

5

4

Figure 15

2

1

1

7

Oil 

Grease

OS0642
OS0741

WARNING: AVOID INJURY. Read 
and understand the entire Safety 
section before proceeding.

WARNING: AVOID INJURY. Read 
and understand the entire Safety 
section before proceeding.