Ariens sno-thro 924126 st11526dle ユーザーズマニュアル
GB - 22
DISCHARGE CHUTE
If chute does not stay in position while
operating, tighten nut on carriage bolt at pivot
point to increase tension on spring (Figure 17).
operating, tighten nut on carriage bolt at pivot
point to increase tension on spring (Figure 17).
RUNNERS
Runners should be adjusted (Figure 18) as
conditions require.
conditions require.
1. Position unit on a hard, flat, smooth level
surface.
2. Adjust runners by inserting a spacer of
desired thickness under center of scraper
blade, loosen runner hardware, slide
runners to flat surface. Allow 1/8 in.
(3 mm) between scraper blade and hard
smooth surfaces. Allow 1-1/4 in. (30 mm)
between scraper blade and uneven or
gravel surfaces. Retighten hardware.
blade, loosen runner hardware, slide
runners to flat surface. Allow 1/8 in.
(3 mm) between scraper blade and hard
smooth surfaces. Allow 1-1/4 in. (30 mm)
between scraper blade and uneven or
gravel surfaces. Retighten hardware.
NOTE: Keep housing level by adjusting
runners equally.
runners equally.
Figure 16
1. Nut
2. Pressure Flange
3. Adjusting Nuts
4. Cable Support Bracket
2. Pressure Flange
3. Adjusting Nuts
4. Cable Support Bracket
OS6700
1
2
3
4
1, 2
Figure 17
1. Carriage Bolt
2. Spring
2. Spring
DS6730
OS0001
1, 2