Philips hts5506-f8 ユーザーズマニュアル

EN - 42

Set up network connection settings in order to use 
BD-Live™, DLNA home media server, Netflix / Film Fresh 
/ Blockbuster / VUDU / Pandora or network update 
function.

„

After you enable a network connection or change the 
network settings, always perform the connection test to 
check if the connection is correctly made.
1. Use [

] to select “Setup” in the home 

menu, then press [OK].

2. Use [

] to select “Network Setup”, then press 

[OK].

3. Use [

] to select “Network Installation”, then 

press [OK].

4. Use [

] to select “Connection Test”, then     

press [OK].
• Connection test will start automatically and the test 

result will appear right after the connection test 
finishes.

- “Connecting...”: The test is in progress.
- “Pass”: Connection test is successfully completed.
- “Failed”: Connection test failed. Check the 

connection settings.

5. Press [OK] to go back to the setup menu, or press 

(home)] to exit.

D Note

•

If the connection test passes, you are ready to use 
BD-Live™, DLNA home media server, Netflix / 
Film Fresh / Blockbuster / VUDU / Pandora or network 
update function, using the Internet without making any 
additional settings.

•

If the connection test fails, you may need to check your 
router settings and make sure the physical connection 
is secure. If you need the MAC address of this unit to 
complete your router settings, you can view it on the 
“View Network Settings” / “View Wireless Settings” 
screen (refer to page 45).

•

When connecting this unit directly to a modem for the 
first time or connecting it to a modem which was 
previously connected to any other network device (e.g. 
a router, PC, etc.), you may have to power cycle the 
modem to reset the settings on the modem.

„

Select “Wired” if you made a wired connection and set the 
setting to “Auto Setup” or “Manual Setup”, in accordance 
with your network environment.

Select “Auto Setup” to set the network setting 
automatically.
1. Follow steps 1 to 3 in “Connection Test” on page 42.
2. Use [

] to select “Start”, then press [OK].

3. Use [

] to select “Wired”, then press [OK].

4. Use[

] to select “Auto Setup”, then press [OK].

• The unit will start the connection test automatically 

and the test result will appear right after the 
connection test finishes.

5. Select “Finish” to activate the network settings and set 

the network connection automatically.

In following cases, select “Manual Setup” to set each setting 
as necessary.
-

When connection test failed with the setting of 
“Auto Setup”.

-

When instructed by your Internet service provider to 
make specific settings in accordance with your network 
environment.

1. Follow steps 1 to 3 in “Auto Setup” on page 42.
2. Use [

] to select “Manual Setup”, then press 

[OK].

3. Use [

] to select “IP Address”, then press [OK].

 (home)

A

“Setup”

A

“Network 

Setup”

A

“Network 

Installation”