Philips mcd280-21m ユーザーズマニュアル
18
English
Preparations
IMPORTANT!
– Make sure to complete the
preparation procedures before operating
the system.
– Make sure to complete the
preparation procedures before operating
the system.
Step 1: Inserting batteries into
the remote control
1
Open the battery compartment.
2
Place two batteries (Type R06 or AA) in the
compartment with the correct polarity as
indicated by “+” and “–” symbols.
compartment with the correct polarity as
indicated by “+” and “–” symbols.
3
Close the cover.
Using the remote control to operate the
system
system
1
Point the remote control directly at the remote
sensor (iR) on the front panel.
sensor (iR) on the front panel.
2
Select the source you wish to
control by pressing one of the
source select buttons on the
remote control (for example
TAPE, TUNER).
control by pressing one of the
source select buttons on the
remote control (for example
TAPE, TUNER).
3
Then select the desired function
(for example 2;, í, ë).
(for example 2;, í, ë).
CAUTION!
– Remove batteries if they are
exhausted or will not be used for a long
time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed of properly.
– Remove batteries if they are
exhausted or will not be used for a long
time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed of properly.
Step 2: Setting the clock
1
Go to Standby mode.
2
Press and hold CLOCK SET.
➜
“
SET CLOCK” will appear, followed by ““0:
00”.
3
Press VOLUME -/+ on the system to set the
hours.
hours.
4
Press CLOCK SET again.
5
Press VOLUME -/+ on the system to set the
minutes.
minutes.
6
Press CLOCK SET to confirm your setting,
and then go into standby mode. The system will
store the setting automatically.
and then go into standby mode. The system will
store the setting automatically.
➜
The time setting becomes effective.
To exit the setting without storing
●
Press STANDBY ON to exit setting mode and
go into STANDBY mode.
go into STANDBY mode.
●
You can also press SOURCE to exit setting
mode and go into disc mode.
mode and go into disc mode.
●
The system will also exit setting mode and go to
tuner, AUX, tape mode when you press the
corresponding source button.
tuner, AUX, tape mode when you press the
corresponding source button.
Note:
– The clock will be cancelled when the power cord
is disconnected or if a power failure occurs.
– The clock will be cancelled when the power cord
is disconnected or if a power failure occurs.