Philips VRKD12BL ユーザーズマニュアル
Before Using Your VCR 5
Putting Batteries in the Remote Control
●
In this VCR, use only tapes with the mark.
●
Remove any stickers or labels from the video cassette tape before
putting the tape in the VCR. Labels can jam the VCR.
putting the tape in the VCR. Labels can jam the VCR.
●
Video heads are an important part of your VCR. You can’t see
them, but the VCR automatically cleans its video heads. The video
heads will require replacement eventually. Only an authorized ser-
vice center should replace the heads.
them, but the VCR automatically cleans its video heads. The video
heads will require replacement eventually. Only an authorized ser-
vice center should replace the heads.
1
Remove the battery compartment lid on the bottom of the
remote control by pressing the tab, then lifting the lid.
remote control by pressing the tab, then lifting the lid.
2
Insert two AA batteries inside the battery compartment with
their + and – ends placed as shown in the picture at right.
their + and – ends placed as shown in the picture at right.
3
Replace the battery compartment lid.
Video cassette tapes have tabs to make sure recordings are not
erased accidentally. The tab is in the bottom left corner on the
front of the tape.
erased accidentally. The tab is in the bottom left corner on the
front of the tape.
1
To keep from erasing a tape, break off the tab with a screwdriver.
2
To allow new recording on the tape, cover the hole with clear tape.
Erasure Prevention
VCR maintenance
• The remote control and its batteries
are supplied.
• Do not mix alkaline and manganese
batteries.
• Do not mix old and new batteries.
Helpful Hints
1
3
2
1
2
Using the Remote Control Holder
When you do not use the remote control, keep it in the remote
control holder (supplied).
control holder (supplied).
1
Insert the bent hooks (A) of the remote control holder into the
fourth row of holes (C) on the right side of the VCR. Make sure
the top hook is in the top hole.
fourth row of holes (C) on the right side of the VCR. Make sure
the top hook is in the top hole.
2
Pop the straight hooks (B) of the remote control holder into the
first row of holes (D) on the right side of the VCR.
first row of holes (D) on the right side of the VCR.
B
A
Remote Control
Holder (as seen
from top)
Holder (as seen
from top)
D
C