Maytag mat12prb ユーザーズマニュアル

©2003 Maytag Appliances Company

16022842  Rev. 0

21

To avoid risk of electrical shock, personal injury or death;
disconnect power to unit before servicing.

1.  Disconnect power supply to unit.
2.  Remove Service Access Door and Coin Box.
3. Disconnect wires from the switch.
4.  Squeeze the two tabs on the switch and push the

switch through towards the front.

Reinstalling  the Lid
1.  Place a hinge ball in the recess of the left side of the

top cover.  Holding it in position, place the lid over the
ball so the ball is in the recess on the left side of the
lid.

2.  Hold the lid with the left hand as shown,  keeping

sufficient pressure against the left side to ensure the
hinge ball will remain wedged between the lid and the
top cover.

3.  With the right hand , place a hinge ball in the right

side of the Top Cover recess.

4.  Push the lid down against the hinge ball on the right

side and with the right thumb.  Press down sharply to
engaged the lid with the hinge ball on the right side.

1.  Disconnect  power supply to unit.
2. Raise the lid where it is at a 45 degree angle.
3.  With the left hand, grasp the left side of the lid toward

the back.  With the right hand, grasp the right side of
the lid at the front right corner.

4.  Taking care to watch the right hinge ball, pull towards

you with the right hand.  When the lid is disengaged
from the right side of the top cover, catch the right
hinge ball, remove the lid and catch the left hinge ball.

4.  Disconnect wires from the switch, and squeeze tabs

on switch to remove from bracket.

1.  Disconnect power supply to unit.
2.  Remove Service Access Door.
3.  Remove the screw securing the switch mounting

bracket and lift the switch from inside the Meter Case.

1.  Disconnect power supply to unit.
2.  Remove Control Panel and disconnect Coin Sensor

connector plug on the Control Board.

3.  Unlock service access door.
4.  Remove Coin Drop Acceptor.