Maytag mat12prb ユーザーズマニュアル

22

16022842  Rev. 0

©2003 Maytag Appliances Company

To avoid risk of electrical shock, personal injury or death;
disconnect power to unit before servicing.

If the fit between the right hinge ball and the lid is

so tight you cannot press it into position with the
right thumb, carefully strike the right corner of the
lid with the palm of the hand to snap it into
position.

1. Disconnect power supply to unit.
2. Remove two T-25H Torx screws securing front panel.
3. Pull front panel up and away from the bottom.

1. Disconnect power supply to unit.
2. Remove Front Panel.
3. Remove two top cover bolts and tilt Top Cover back.
Note:

Hold lid closed or tape lid to the Top Cover to

prevent it from striking the Control Panel.

1. Disconnect power supply to unit.
2. Secure Lid to the Top cover.
3. Remove Front Panel.
4. Remove screw securing Top cover to the cabinet.
5. Tilt Top backwards.
6. Remove tub cover by unsnapping the tabs securing

Tub Cover to the Outer Tub.

1. Disconnect power supply to unit.
2. Remove Tub Cover.
3. Insert a pencil or other small pin through the three

small holes in the outer tub depressing the tabs on
the Balance Ring.