Directed Electronics avital 3300l ユーザーズマニュアル
23
© 2011 directed electronics—all rights reserved
23
To enter or exit Valet Mode using the remote:
Steps 2 through 3 must be quickly and smoothly completed.
1. Open any vehicle door.
2. Press
.
3. Press
.
4. Press
again.
The status LED will light solidly if you are entering Valet Mode,
and it will go out if you are exiting Valet Mode.
and it will go out if you are exiting Valet Mode.
setting the clock
To set the clock press and hold
for five seconds, the trans-
ceiver will chirp twice and the hour selection will start flashing.
Immediately press
Immediately press
to advance the hour selection or
to
reverse the hour selection. Once the correct hour is displayed
press
press
again and the minute selection will start flashing. Then
press
to advance the minute selection or
to reverse the
minute selection. Once the correct time is displayed simply stop
pressing any buttons for 15 seconds and the transceiver will auto-
matically exit the clock mode.
pressing any buttons for 15 seconds and the transceiver will auto-
matically exit the clock mode.
nuisance prevention
®
circuitry
Your system has Directed’s Nuisance Prevention
®
Circuitry
(NPC
®
). It pre vents annoying repetitive trigger sequences due
to faulty door pin switches or en vi ron men tal con di tions such as
thunder, jack ham mers, airport noise, etc.
thunder, jack ham mers, airport noise, etc.