Directed Electronics avital 3300l 用户手册

To enter or exit Valet Mode using the remote:

Steps 2 through 3 must be quickly and smoothly completed.

1. Open any vehicle door.

2. Press

3. Press

4. Press

again.

The status LED will light solidly if you are entering Valet Mode,
and it will go out if you are exiting Valet Mode.

setting the clock

To set the clock press and hold

for five seconds, the trans-

ceiver will chirp twice and the hour selection will start flashing.
Immediately press

to advance the hour selection or

reverse the hour selection. Once the correct hour is displayed
press

again and the minute selection will start flashing. Then

press

to advance the minute selection or

to reverse the

minute selection. Once the correct time is displayed simply stop
pressing any buttons for 15 seconds and the transceiver will auto-
matically exit the clock mode.

nuisance prevention

circuitry

Your system has Directed’s Nuisance Prevention

Circuitry

(NPC

). It pre vents annoying repetitive trigger sequences due

to faulty door pin switches or en vi ron men tal con di tions such as
thunder, jack ham mers, airport noise, etc.