Mitsubishi Electronics XD3200U ユーザーズマニュアル
EN-11
1
Enter “9” and press the Enter key.
2
The setting screen is shaded and the setting is
updated.
updated.
It takes about 10 seconds for the setting to be
•
updated. Don’t perform communication during
this period.
this period.
Save and exit
Because the password, display language, LAN control, and PJLink™ certification are set using the telnet
•
function, you can also set them on the command prompt window of the personal computer. Enter the following
command and press the Enter key.
command and press the Enter key.
> telnet [IP address you set] 9999
[“>” shows a prompt.]
When setting menu appears, perform the setting procedure as described above.
(Note)
Check that the port number “9999” isn’t blocked by the firewall.
(Note)
Check that the port number “9999” isn’t blocked by the firewall.
Preparation/SetUp (continued)
1
Enter “5” and press the Enter key.
When you don’t use PJLink™ protocol
•
communication, skip this item. (See page 16 for
PJLink™.)
PJLink™.)
2
To enable the PJLink™ certification, enter “1” and
press the Enter key. To disable it, enter “0” and press
the Enter key. (Default is ON (1).)
press the Enter key. To disable it, enter “0” and press
the Enter key. (Default is ON (1).)
Setting the PJLink™ certification (PJLink certification Mode)