Mitsubishi Electronics XD3200U ユーザーズマニュアル
EN-8
1
Start the Projector-Control Device Installer.
Select [Start] - [All Programs] - [Projector] -
•
[Projector-Control Device Installer] (in the case of
Windows
Windows
®
XP).
2
Press the + buttons on the left pane to expand the
tree structure until the IP address you set appears.
tree structure until the IP address you set appears.
3
Click the Telnet Configuration tab.
4
Select the Connect tab. Press the Enter key within
5 seconds after the message shown on the right
appears.
5 seconds after the message shown on the right
appears.
When it passes 5 seconds without any operation
•
on this screen, the screen is shaded and no key
operation is accepted. In this case, click the
Connect button again to continue setting.
operation is accepted. In this case, click the
Connect button again to continue setting.
5
The setting menu appears.
Telnet setting
Setting of password, display language, LAN control, and PJLink™ certification using telnet.
This section describes how to set the password, display language on the ProjectorView screen, LAN control, and
PJLink™ certification that are necessary for the operation state control tool (commercially available) that uses the
projector operation control/monitor tool ProjectorView and the industry standard PJLink™ protocol.
This section describes how to set the password, display language on the ProjectorView screen, LAN control, and
PJLink™ certification that are necessary for the operation state control tool (commercially available) that uses the
projector operation control/monitor tool ProjectorView and the industry standard PJLink™ protocol.
Preparation/SetUp (continued)