Mobi Technologies MOBICAM 70060 ユーザーズマニュアル

ページ / 8
INSTALLATION & SET UP
Installing Batteries
Your MobiCam AV can be powered by either using the supplied 
AC power adaptors or batteries. 
Using Batteries:
a) Remove the battery door (12, 26) at the bottom/ back of each 
unit by loosening the child-safe screw (14, 25) and sliding the 
cover downward to release.
b) Both units use 1.5 volt AA size batteries. Always use batteries of 
the same brand and age (alkaline recommended). Insert 4 AA 
batteries into the camera and 6 AA batteries into the monitor.
c) Replace the covers by aligning the tabs with the tab holes and 
tightening the child-safe screws.
CAUTION: Remove batteries immediately once they run out of 
power and dispose of them properly. Do not use batteries while 
using the AC adaptor for extended periods of time as this might 
cause battery leakage.
Using AC Adaptors:
a) Insert the AC adaptor into the DC Jack (9, 23) of either unit (The 
AC adaptors are the same for both the Camera and Monitor).
b) Plug the AC adaptor plug into a standard AC power outlet.
CAMERA OPERTATION & INSTALLATION
Power ON/OFF
Use the Power ON/OFF sliding switch to turn ON/OFF the unit (21). 
Channel Selection
Press the Channel Selection Switch (17) on the Camera to choose 
which channel you want the unit to transmit on. The channel 
indicator LED (16) will illuminate which channel the Camera is set 
to (A or B).
 
Voice Activation
To Activate: Select the VOX setting on the Function Activation 
Switch (18)on the left side of the Camera unit. When the sound 
level within the area surrounding the unit reaches a preset level, 
the Camera will begin transmitting the image and sound to the 
Monitor.
NOTE: The LCD on the Monitor unit will automatically switch to 
standby mode if no signal is received from the Camera
To Deactivate: Select the CAMERA setting on the Function Activa-
tion Switch of your camera.
Automatic Infra-Red Night Vision
The infra-red night vision feature will switch on automatically 
during darkness or periods of very low levels of light and a black 
and white image will be displayed on the monitor. Once the feature 
is activated objects must be within 6 ft/ 2 m of the camera to be 
seen on the monitor.
 
 
 
 
 
 
 
 
 
 
8