Intel esm-2850 2047285001r ユーザーズマニュアル

ページ / 91
ESM-2850 
48 ESM-2850 User’s Manual 
 
 
3.5.2.7  Swap Floppy Drive 
While system has two floppy drivers installed, this item will be affected. This function is to 
assign physical drive B to logical drive A 
Item 
Description 
Enabled 
Assign physical drive B to logical drive A 
Disabled No 
change 
3.5.2.8  Boot Up Floppy Seek 
Seeks disk drives during boot up. Disabling seeds boot up. 
Item 
Description 
Enabled 
Enable Floppy Seek 
Disabled 
Disable Floppy Seek 
3.5.2.9  Boot Up NumLock Status 
Select power on state for NumLock. 
Item 
Description 
On Enable 
NumLock 
Off Disable 
NumLock 
3.5.2.10  Gate A20 Option 
Select if chipset or keyboard controller should control Gate A20. 
Item 
Description 
Normal 
A pin in the keyboard controller controls Gate A20 
Fast 
Lets chipset control Gate A20   
3.5.2.11  Typematic Rate Setting 
Key strokes repeat at a rate determined by the keyboard controller. When enabled, the 
typematic rate and typematic delay can be selected. 
Item 
Description 
Enabled 
Enable typematic rate/delay setting 
Disabled 
Disable typematic rate/delay setting 
3.5.2.12  Typematic Rate (Chars/Sec) 
Sets the number of times a second to repeat a key stroke when you hold the key down.
 
The choice: 6, 8, 10, 12, 15, 20, 24, 30. 
3.5.2.13  Typematic Rate (Msec) 
Sets the delay time after the key is held down before it begins to repeat the keystroke.
 
The choice: 250, 500, 750, 1000. 
3.5.2.14 Security Option 
Select whether the password is required every time the system boots or only when you 
enter setup. 
Item 
Description 
System 
The system will not boot and access to Setup will be denied if the correct password is 
not entered at the prompt. 
Setup 
The system will boot, but access to Setup will be denied if the correct password is not 
entered at the prompt.