Metra Electronics 99-7877s ユーザーズマニュアル
99-7877S DASH DISASSEMBLY
HONDA FIT 2009-10
1
1
Remove (1) 8 MM bolt facing up
behind center panel.
Note: Slide the recirculation
control lever to FRESH for better
access to bolt. (Figure A)
behind center panel.
Note: Slide the recirculation
control lever to FRESH for better
access to bolt. (Figure A)
Disconnect the negative battery
terminal to prevent an accidental
short circuit.
terminal to prevent an accidental
short circuit.
3
Unclip and remove the lower center
panel below radio. (Figure A)
panel below radio. (Figure A)
2
Remove (2) Phillips screws securing
the hazard switch to the back of the
factory radio panel. (Figure D)
the hazard switch to the back of the
factory radio panel. (Figure D)
5
Remove (2) Phillips screws securing
the air bag light to the back of the
factory radio panel. (Figure E)
the air bag light to the back of the
factory radio panel. (Figure E)
6
Remove (5) Phillips screws securing
the a/c vents to the radio panel.
the a/c vents to the radio panel.
Remove (7) retaining clips from radio
housing to be used later in kit
preparation.
housing to be used later in kit
preparation.
8
7
Open the upper glove box then use
a pry tool to unclip and remove the
radio/climate control assembly.
(Figure B & C)
a pry tool to unclip and remove the
radio/climate control assembly.
(Figure B & C)
4
Continue to kit preparation.
A
B
C
D
E