Mitsubishi Electronics colorview xd480u ユーザーズマニュアル

EN - 23

You can install other device's remote commands in the 
remote control of this projector.

How to install
1.  Set the SELECT switch of the remote control of this 

projector to DVD or VIDEO, depending on the device 
you use.

2.  Place the remote control of this projector and that of 

the other device with their transmission windows 2-5 
cm apart.

3.  Press the MEMORY button.

• 

The MEMORY button will blink red.

• 

To cancel the installation, press the MEMORY 
button again.

4.  Press any programmable button on the remote con-

trol of this projector.
• 

The MEMORY button will stop blinking and stay 
on.

• 

When no button is pressed for 6 seconds after 
step 3 and 4, the MEMORY button will go out au-
tomatically.

2 - 5cm

MEMORY button

SELECT switch

Programmable buttons

5.  Hold down the button on the other device's remote 

control whose command you want to install until the 
MEMORY button start blinking. 
• 

When the MEMORY button blinks six times and 
then goes out, the function has been installed 
successfully.

• 

When the MEMORY button doesn't blink before 
going out, the installation has failed.

• 

To continue to install other functions, repeat step 
3 to 5.

Important:
• 

Some special commands are not memorized, de-
pending on the type of the remote control.

• 

Do not install any remote commands of other de-
vices including air conditioners than video devices. 

How to use the installed functions
1.  Set the SELECT switch of the remote control of this 

projector to DVD or VIDEO, depending on the device 
you use.

2.  Press the programmable button in which the desired 

remote command has been installed.