Hitachi cx39e(bs) ユーザーズマニュアル

PROG.

PLAY

PROG.

PLAY

FUNCTION DISPLAY

The function display shows you various playing modes, track numbers.

No disc is inserted in the CD compartment.

The unit is in the stop mode.

During playback.



While player is set to pause

During programming



Track number will be stored

While CD door is opened

NOTES ON HANDLING COMPACT DISCS

¨ Keep the disc clean, hold the disc by its edge. Do not touch the surface.

¨ Do not stick paper or tape nor write anything on the surface.

¨ After playing, store the disc in its case.

TO LISTEN TO A RADIO STATION

1. Set FUNCTION SELECTOR (10) to “RADIO ” position.
2. Set BAND SELECTOR (7) to the desired band.

3. Tune to the desired station by turning the TUNING CONTROL (9).

4. Adjust VOLUME CONTROL (1) and SURROUND BUTTON (3) to suit your personal

listening preference.

5. To switc h off the radio, set the FUNCTION SELECTOR (10) to TAPE (CD RADIO OFF).

TO PLAY A CASSETTE

For operating the cassette deck, follow the steps below:

1. Set FUNCTION SELECTOR (10) to “T APE (CD RADIO OFF) ” position.
2. Insert a recorded cassette tape with the tape surface up.

3. Press PLAY button on cassette deck to begin playback.
4. To stop the tape, pr ess STOP/EJECT button on cassette deck.

Before inserting a cassette, slack of tape must roll up to prevent tangling around the
capstan.

TO RECORD TO A CASSETTE TAPE

Your equipment is able to record your desired sound source either through RADIO program or
the CD.

1. Insert a blank cassette tape into cassette deck.

2. Select your desired source by setting FUNCTION SELECTOR (10) to CD or Radio.

3. Depress PAUSE button on cassette deck.

4. Depress RECORD & PLAY button on cassette deck.

5. To start recording, press PAU SE button on cassette deck again.

6. To stop recording, press STOP/EJECT button on cassette deck.

Use only NORMAL tapes in the cassette deck of this sound system. The characteristics of the
cassette deck mechanisms do not match other types of tape.

TAPE RECORDER SECTION

A) TO RECORD FROM RADIO TO A CASSETTE TAPE

TO RECORD FROM CD PLAYER TO A CASSETTE TAPE

C) CD TO TAPE SYNCHRONISED RECORDING

Select your desired band (7) and follow steps 1 - 6.

Place the CD in the CD compartment. Key in the program play settings on the CD

settings. If necessary.

Then, follow the steps 1 - 6.

Insert a blank cassette tape into the deck.

Place the CD in the CD compartment.

Move the FUNCTION SELECTOR (10) to select CD.

Press RECORD key and PLAY key will automatically engage. CD will play

automatically (Synchro Recording From CD).

Pres s STOP/EJECT to end recording.

NOTE: If you select any track, other than track 1 to begin, you must press the RECORD and

play key within two (2) seconds after selecting that specific track to start.

English