Hitachi cx39e(bs) ユーザーズマニュアル

MAINTENANCE

¨ CLEANING OF HEADS AND TAPE PATH

We recommend cleaning after every 10 hours of operation. To make the best possible
recordings, you should clean all surfaces which the tape travels before every recording.

1. Press STOP/EJECT button to op en the cassette holder.

2. Wipe the heads, pinch roller and capstan with cleaning tip slight hoisted with cleaning

fluid or alcohol.

3. After cleaning the heads and tape path, do not insert a cassette until the areas cleaned

are completely dry.

CLEANING THE CABINET

Clean the cabinet, panel and controls with a soft cloth light moisted with a mild detergent
solution. Do not use any type of adrasive pad, scouring powder or solvent such as alcohol or
benzine.

¨ The recording level is automatically adjusted by built - in ALC circuit.

¨ The recording level is not affected by the VOLUME CONTROL (1) AND SURROUND

button (3), so you can listen to the program with surround and any level of volume that
you want.

WARNING:

Copying of such material requires the permission of the owner.

1. Set FUNCTION SELECTOR (10) to “T APE (CD RADIO OFF) ” position.

2. Insert recorded cassette into the cassette deck.

3. Depress RECORD & PLAY button on cassette deck.

4. To stop erasing, press STOP/EJECT button on cassette deck.

TAPE ERASING

Before you jump to the conclusion that the unit is out of order!

When the set is not operating properly, one is apt to assume that the set is faulty. There are, however,
many possible faults which are not directly attributable to the set itself. It is rec

ommended to check the

following before taking the set to a Hitachi dealer.

CHECK THE FOLLOWING BEFORE CALLING FOR SERVICE

Symptom

Cause/Method of solution

NO AC power

Is the power cord connected properly?

NO DC power

Are the batteries properly inserted in the battery

compartment?

Tape does not run when a button

is pressed.

Are the batteries exhausted?

Cassette can not be inserted.

Is the cassette upside down?

No recording.

Is the Pause button pressed? If so, unlock and release.

Are the accidental - erasure prevention tabs punched

out? If so, cover the holes with plastic tape.

Sound deterioration or irregular

tape speed.

Clean heads, capstan and pressure roller with a

cleaning stick.

Slow tape speed or low volume.

Are the batteries exhausted?

Disc is not played.

Is the disc loaded upside down?

Is the disc scratched or warped?

Is the pick - up lens dirty? If so, clean it with a cleaning

stick.

Player does not operate correctly;

sound is interrupted, noise occurs

and tracks cannot be selected.

Is the disc scratched or otherwise flawed?

Is the disc soiled?

Player does not operate normally

when control butt ons are pressed.

First, press the Stop button then play the disc again.

l a

English