Vertex Standard FT-2000 ユーザーズマニュアル

Page 118

FT-2000 O

PERATING

ANUAL

061 A1A FRQDISP

Function: Selects the frequency Display Format for the
CW mode.
Available Values: dir/OFSt
Default Setting: OFSt

dir (Direct Frequency): Displays the receiver carrier

frequency, without any offset
a d d e d . W h e n c h a n g i n g
modes between SSB and CW,
the frequency display re-
mains constant.

OFSt (Pitch Offset):

This frequency display re-
flects the added BFO offset.

062 A1A PC KYNG

Function: Enables/disables CW keying from the “DATA
IN” terminal on the rear panel’s PACKET jack while op-
erating on the CW mode.
Available Values: EnA (Enable)/diS (Disable)
Default Setting: diS (Disable)

063 A1A QSKTIME

Function: Selects the time delay between when the PTT
is keyed and the carrier is transmitted during QSK opera-
tion when using the internal keyer.
Available Values: 15/20/25/30 msec
Default Setting: 15 msec

MODE-DAT G

ROUP

064 dAtA DATA IN

Function: Selects the data input path to be used on the
PKT mode.
Available Values: dAtA/PC
Default Setting: dAtA

dAtA:Uses the data input line connected to pin 1 of

the PACKET jack while using the PKT mode.

PC:

This parameter is for future expansion of this
transceiver’s capabilities, but at this time is not
supported.

065 dAtA DT GAIN

Function: Sets the data input level from the TNC to the
AFSK modulator.
Available Values: 0 ~ 100
Default Setting: 50

066 dAtA DT OUT

Function: Selects the receiver to be connected to the data
output port (pin 4) of the PACKET jack.
Available Values: nAin (Main)/Sub (Sub)
Default Setting: nAin (Main)

067 dAtA OUT LVL

Function: Sets the AFSK data output level at the output
port (pin 4) of the PACKET jack.
Available Values: 0 ~ 100
Default Setting: 50

068 dAtA VOX DLY

Function: Adjusts the “VOX” delay (receiver recovery)
time on the PKT mode.
Available Values: 30 ~ 3000 msec
Default Setting: 300 msec

069 dAtA V GAIN

Function: Adjusts the “VOX” gain on the PKT mode.
Available Values: 0 ~ 100
Default Setting: 50

070 dAtA PKTDISP

Function: Sets the packet frequency display offset.
Available: –3000 ~ +3000 Hz (10 Hz/step)
Default: 0 Hz

071 dAtA PKT SFT

Function: Sets the carrier point during the SSB packet
operation.
Available: –3000 ~ +3000 Hz (10 Hz/step)
Default: 1000 Hz (typical center frequency for PSK31,
etc.)

MODE-CW G

ROUP

ENU

ODE