Uniden UBCT9 ユーザーズマニュアル

Read the descriptions of the Plan 1~2 for details on which may apply for you.
PL(plan): If the last three digits of ALL the frequencies in use end in one of the following
three digits (125, 375, 625, or 875), use PL1(plan1).

PL (plan ): If the last three digits of ALL the frequencies in use end in one of the
following three digits (000, 250, 500, or 750) use Plan 2.

Of course, you will know the Control Channel frequency itself so that will help you 
determine the proper plan. If you try one plan and you receive errors (such as the scanner 
jumping to channels that are obviously not part of the system), you should try an alternate 
Plan.

Note:  •  You can assign a Fleet Map to TYPE 1 or Hybrid systems scanned in Control
 

  Channel Only mode by going into the Trunk Programming mode. You can also    

 

  program IDs, set a delay, and all the other parameters for systems scanned in this

 

  mode. You can then either search the system to find new IDs or you can program

 

  IDs into memory and then scan them.

 

•  The Control Channel Only feature is an extremely powerful tool. You can use it to

 

  determine if systems you are familiar with may have added new frequencies or    

 

  you can use it to discover new systems by simply finding active control channels   

 

  (using Search) and then programming them for Control Channel operation only.

 

  Remember that this feature only applies to Motorola 800 systems, that you do    

 

  have to set the proper system type (800 MHz of Type 1 or Type 2) and you do 

 

  have to program the Control Channel frequency into memory and identify the  

 

 

  frequency as trunked in the Trunk Programming mode.

When this function is disabled, the radio looks for squelch before returning to the Control
Channel instead of waiting for the Disconnect Tone. Only in rare instances will you need to
adjust the default settings. The condition to return to Control Channels depends on whether
the signal is present or not.

1.   Press and hold TRUNK for 1.5 seconds and select the bank you want to change.

2.   Use the    or    key to select 

 (Motorola TYPE2 800MHz), 

 (Motorola  

  

 

Type2 VHF) or  

 (Motorola Type2 UHF), then press E.

3.   Use the    or    key to select 

, then press E.

4.   Use the    or    key to select 

 or 

, then press E. 

Note:  Set the SQL control so that you hear a hissing, and the scanner will remain on the
 

  voice channel (even when a disconnect tone is transmitted or there is no signal 

 

  at all).

UBCT9 OM   47

12/11/07   3:54:01 PM