Vulcan Materials itw 36rrg ユーザーズマニュアル

 

- 

6

 - 

 

 

The Control Panel holds the 
thermostats, indicator lights 
and power switch. 
 

1.  Remove the four screws 

securing the front of the 
control panel.  There are 
two screws at each end 
of the panel. 

2.  Remove the screws that 

secure the bottom of the 
control panel to the 
underside of the chassis. 

3.  Pull the control panel 

forward and lay face 
down directly in front of 
the unit while servicing. 

4.  Reverse the procedure to 

install. 

 

The Bullnose acts as a front 
rail or shelf during griddle 
operation. 

1.  Remove the Control 

Panel. 

2.  The bullnose assembly is 

secured with several 
screws, one at each end 
of the bottom of the        
assembly and several 
more (depending on 
size) facing the griddle 
plate. 

3.  Reverse the procedure 

to install. 

 

It will be necessary to remove the back panel when changing a 
burner, temperature probe or to remove excessive grease build up 
from the flue area. 

 

1.  Disconnect gas supply at griddle. 
2.  Remove all screws from rear of griddle securing the back panel. 
3.  Reverse the procedure to install. 
 

The identification plate contains the unit’s full model and serial 
number along with BTU rating and clearance information.  The 
identification plate is located on the right side panel towards the 
front of the unit. 
 

The flue is the outlet for gases left over from combustion and 
excess heat. The flue should never be blocked or covered.