Vulcan Materials itw 60rrg ユーザーズマニュアル

 

- 

16

 - 

 

2.  Reach through the back of the unit.  Squeeze the burner retaining clip and slide off burner 

retaining pin. 

3.  Lift the burner up so the retaining pin clears the corresponding hole in the chassis, then pull 

the burner out through the back of the unit. 

4.  Replace by inserting the burner through the rear of the unit and engaging the burner venturi 

onto the burner orifice at the front of the unit.  

5.  Seat the retaining pin in the hole in the chassis and attach the retaining clip. 
6.  Remove the control panel to check that the venturi is properly fitted over the orifice. 
7.  Reassemble the control and back panels, then check for proper operation. 
 
 

 

 

For efficient burner operation, it is important that a proper balance of gas volume and primary air 

supply is maintained to give complete combustion.  Insufficient air supply results in a yellow streaming 
flame.  Primary air supply is controlled by the air shutter on the front of the burner venturi.  Loosen the 
screw on the venturi and adjust the air shutter to just eliminate yellow tips on the burner flames.  Lock 
the air shutter in place in place by tightening the screw.  Repeat this procedure as necessary with all 
burners. 
 
 
 

    

 

 

These photos are for reference – it should not be necessary to remove the griddle top to perform the 
procedures listed in this manual.