Viking D3 ユーザーズマニュアル

33

E

Cleaning and Maintenance

Occasionally, a cooking odor may remain in the Built-in Microwave 
Hood. To remove, combine 1 cup water, grated peel and juice of one 
lemon and several whole cloves in a 2-cup glass measuring cup. Boil for 
several minutes using 100% power. Allow to set in the Built-in Micro-
wave Hood until cool. Wipe interior with a soft cloth.

The turntable and turntable support can be removed for easy cleaning. 

Wash them in mild, sudsy water; for stubborn stains use a mild cleanser 

and non-abrasive scouring sponge. They are also dishwasher-proof. Use 

upper rack of dishwasher. The turntable motor shaft is not sealed, so 

excess water or spills should be wiped up immediately.

The waveguide cover is located on the right side wall of the oven cav-

ity. It is made from mica so requires special care. Keep the waveguide 

cover clean to assure good oven performance. Carefully wipe with a 

damp cloth any food spatters from the surface of the cover immediately 

after they occur. Built-up splashes may overheat and cause smoke or 

possibly catch fire. DO NOT REMOVE THE WAVEGUIDE COVER.

Filters should be cleaned at least once a month. Never operate the fan 

or oven without the filters in place.
1.  Pull down slightly on the tab toward the front of the oven and re-

move the filter. Repeat for the other filter.

2.  Soak the filters in a sink or 

dish pan filled with hot water 

and detergent. DO NOT use 

ammonia or other alkali; they 

will react with the filter material 

and darken it.

3.  Agitate and scrub with a brush 

to remove embedded dirt.

4.  Rinse thoroughly and shake dry.
5.  Replace by fitting the filter 

back into the opening.

Grease filter

Tab