Crestron electronic WMKT-6X-DSW ユーザーズマニュアル

Trim Ring Mount Kits for the TPS-6X-DSW 

Crestron TMK/WMKT-6X-DSW

This section provides an installation procedure for each Trim Ring Mount Kit. The 
“TMK-6X-DSW Procedure” starts below and the “WMKT-6X-DSW Procedure” 
starts on page 6. Be sure to review each procedure before starting. 

This section provides the necessary steps for the assembly of the TMK-6X-DSW 
with either the BB-6X-DSW or PMK-6X-DSW. It is assumed that the BB-6X-DSW 
or PMK-6X-DSW has been secured to the stud according to the instructions in the 
latest revisions of their Installation Guides (Doc. 6728 and Doc. 6778 respectively). 
It is also assumed that drywall is in place and a cutout for the TPS-6X-DSW is made 
in the drywall. 

Complete the steps in the order provided. The only tool required and not supplied is 
a level. 

NOTE:  When installing into the PMK-6X-DSW, verify that the 18 AWG bus wire 
securing the cables for the wall mount docking station remains attached. 

1.  Verify that the cutout in the drywall is as level as possible. 

2.  Insert the symmetrical trim ring into the opening, as shown in the 

illustration below. 

DRYWALL

TRIM RING
(2022808 )

IMPORTANT
MAKE DRYWALL CUTOUT 
AS LEVEL AND CLEAN AS 
POSSIBLE. THE TRIM RING 
ONLY ALLOWS MINOR 
ADJUSTMENTS OF THE
TPS-6X-DSW.

 

NOTE:  The required PMK-6X-DSW or BB-6X-DSW is not shown in the 
illustration above. 

•  Trim Ring Mount Kits for the TPS-6X-DSW: TMK/WMKT-6X-DSW