Namco Bandai Games 90500094 ユーザーズマニュアル
Page 31
6-4 Linking Two Machines
1.
Ensure that the power is "OFF"
2.
Loosen the two pozi head screws retaining the link cover bracket, located next to
the mains-in socket on the rear of the monitor cabinet, and remove the link cover
bracket.
the mains-in socket on the rear of the monitor cabinet, and remove the link cover
bracket.
3.
Set the slide switch on the link board to 'EXT' on both machines.
4.
Use the supplied link cables to connect each link board. (See Diag.)
5.
Turn the power to each machine "ON", and set the PCB ID using the test mode.
(Refer to section
(Refer to section
Note:- Set the left machine ID to 0 / LEFT and the right hand machine ID to
1 / Right. Settings other than this will cause the machine to operate incorrectly
6.
Refit the link cover bracket and tighten the pozi head screws.
If the machines are used as single, non linked games ensure that the link cables
are removed and the slide switch is returned to the "INT" position.
are removed and the slide switch is returned to the "INT" position.
IN
OUT
Ext
Int
IN
OUT
Ext
Int