Nautilus t516 ユーザーズマニュアル
0
mechanical Service guide
5-5 Loosen the motor tension bolt (see Figure 3) using
a 1/2 inch wrench and then loosen the (4) 1/2 inch
nuts and bolts (heads located under the motor
pan) securing the motor base to the pan, allowing
the motor to slide towards the belt.
nuts and bolts (heads located under the motor
pan) securing the motor base to the pan, allowing
the motor to slide towards the belt.
5-6 Slide the drive belt off the pulley on the end of the
motor shaft.
5-7 Remove the front and rear roller following the
instructions for replacement of the front and rear
roller (Section 1: Replacement of Crowned Front
Roller and Section 3: Replacement of Crowned
Rear Roller).
roller (Section 1: Replacement of Crowned Front
Roller and Section 3: Replacement of Crowned
Rear Roller).
5-8 Place the treadmill on its right side (motor side
towards the floor).
5-9 Remove the (4) nuts on the underside of the
walking board (see Figure 4 and 4A) and loosen
the other (4) tall isolators nearest the floor.
the other (4) tall isolators nearest the floor.
5-10 Remove the walking belt by sliding it off the left
side of the walking board.
NOTE: It will be necessary to raise the left side of
the board slightly from the frame to give
clearance to slide off the belt (see Figure 5).
clearance to slide off the belt (see Figure 5).
5-11 Install the new belt by sliding it over the front and
rear rollers from the left side of the treadmill.
5-12 Reattach the walking board to the frame using
the (4) nuts and isolators removed in Step 9.
Check the remaining nuts and isolators and
tighten.
Check the remaining nuts and isolators and
tighten.
5-13 Attach the front and rear roller to the frame
following the instructions for replacement of
front and rear roller (Section 1: Replacement of
Crowned Front Roller and Section 3: Replacement
of Crowned Rear Roller).
front and rear roller (Section 1: Replacement of
Crowned Front Roller and Section 3: Replacement
of Crowned Rear Roller).
Figure 3:
Figure 4:
Figure 4A: