Desa WMN10 ユーザーズマニュアル

123995-01C

9

Marking Screw Locations
1.  Determine where you will locate heater.

2.  Mark  two  mounting  screw  locations  on 

wall (see Figure 5).

Mounting 

Screw 

Locations

10 

7

/

8

"

Minimum

7 

3

/

4

"

20 

1

/

4

"

Minimum To 

Maintain 3" 

Clearance 

From Floor

FLOOR

JOINING W

ALL

Installing Two Mounting Screws
Note: Wall anchors and mounting screws are 
in hardware package. The hardware package 
is provided with heater.

For attaching mounting screw to wall stud
1.  Drill hole at marked location using 9/64" 

drill bit.

2.  Insert mounting screw into wall stud.
3.  Tighten screw until 1/16" space (thickness 

of  penny)  is  between  screw  head  and 
wall.

Follow instructions below to attach mounting 
screws to hollow walls (wall areas between 
studs) or solid walls (concrete or masonry).
1.  Drill  holes  at  marked  locations  using 

5/16" drill bit. For solid walls (concrete or 
masonry), drill at least 1 

1

/

4

" deep.

2.  Fold wall anchor (see Figure 6).

3.  Insert wall anchor (wings first) into hole. 

Tap anchor flush to wall.

4.  For thin walls (1/2" or less), insert red key 

into  wall  anchor.  Push  red  key  to  “pop” 
open anchor wings (see Figure 7).

 

IMPORTANT:  Do  not  hammer  key!  For 
thick walls (over 1/2" thick) or solid walls, 
do not pop open wings.

5.  Tighten  two  screws  until  1/16"  space 

(thickness  of  penny)  is  between  screw 
heads and wall (see Figure 8).

Thin or 
Thick Wall 
(thick wall 
shown)

Solid 
Wall 

1/16" 
Space 

Placing Heater On Mounting Screws
1.  Locate two keyhole slots on back panel 

of heater (see Figure 9).

2.  Place large openings of slots over screw 

heads. Slide heater down until screws are 
in small portion of slots.

Keyhole Slots