Namco Bandai Games 90500074 ユーザーズマニュアル
Page 82
6.
Replace the motor and reassemble in reverse order.
Note: The shaft of the flat target motor has been ground flat in two places. When
replacing the pulley ensure that the two double point screws are in contact with
these flat faces.
Before tightening the double point screws ensure that the gap between the top
surface of the motor bracket and the pulley is approximately 2mm.
It is recommended that Loctite 242 (part No 95000004) is applied to the double
point screws when refitting the pulley.
Flat Target
Motor Shaft
Pulley
Flat Section
Double Point
(M5x6)
Flat Section
Double Points
(M5x6)
2mm
Pulley
Motor Bracket