Zalman cnps6500b(s) ユーザーズマニュアル

3-Pin CPU Fan

Connector

3-Pin Connector of the Fan

Mainboard

Speed 
Control Knob

FAN MATE 1

4. When removing, press the upper ends of the clips with 

the no-slip surface at a 45-degree angle to separate the 

clips from the Retention Guide as shown above.

* Supplement : If the CPU temperature exceeds 70°C  

even after properly installing the heatsink, add

reinforcers under the two sides of the clip.

5. Install the FAN MATE 1 as shown above.

1. Spread the thermal grease thinly onto the 

CPU core’s surface that comes in contact
with the FHS.

2. Lightly place the heatsink on the CPU.

3. Insert one end of each of the two clips into the holes on the 

Retention Guide. Then press the other ends of the clips  
downwards simultaneously to finish the installation. Try moving
the FHS around with your hand to see that it is properly installed. 

Thermal Grease

Retention Guide

FHS

Clip

Clip

Rein forcer

CPU