Intel SR1680MV ユーザーズマニュアル
30
Intel
®
Server System SR1680MV Service Guide
Pluggable SATA Drive
2.5-inch Pluggable SATA HDD
The sever supports up to four 2.5-inch pluggable SATA HDDs, two on each server board
module. Four HDDs share the same removal and installation procedure. For your
reference, this section provides the steps of removing and installing one 2.5-inch
pluggable SATA HDD as an example.
Figure 33 shows the location of the 2.5-inch pluggable SATA HDD on the server chassis:
Figure 33. 2.5-inch Pluggable SATA HDD Location
Note: Before you remove or install the pluggable HDD, complete the following steps:
1. Make sure the server is not turned on or connected to the AC power. To power off
the server, see
2. Disconnect all necessary cable connections.
3. Remove the HDD blank if the HDD blank is installed.
3. Remove the HDD blank if the HDD blank is installed.
Removing a 2.5-inch Pluggable SATA HDD
1. Turn the lock counter-clockwise.
2. Slide the locking latch along the direction of the arrow.
3. The HDD carrier locking lever springs open by itself.
2. Slide the locking latch along the direction of the arrow.
3. The HDD carrier locking lever springs open by itself.