Namco Bandai Games 90500085 ユーザーズマニュアル
Page 35
7-6 Replacing the Tilt Control Pot
1)
Remove the front vac-form.
(See Section 7-3)
2)
Remove four security head screws (M5x12) and remove the Ski Step front vac-
form.
form.
3)
Disconnect the connector, slacken the pot retaining grub screw (M4x8) and
remove the control pot and bracket.
remove the control pot and bracket.
4)
Replace the control pot taking care to ensure that the wires are replaced to the
correct terminals.
correct terminals.
5)
Reassemble in reverse order.
6)
NOTE: When refitting the control pot ensure that the pot locating tab engages
in the hole in the mounting bracket and that the grub screw (M4x8)
engages on the flat of the pot shaft.
engages on the flat of the pot shaft.