Vulcan Materials vulcan g481 ユーザーズマニュアル
F35425 (October 2005)
Page 8 of 23
ENDURANCE SERIES GAS RANGES - REMOVAL AND REPLACEMENT OF PARTS
5.
Remove the kick plate as outlined under
COVERS AND PANELS.
NOTE: Do not kink the capillary tube when straight-
ening the tubing for removal.
ening the tubing for removal.
6.
Slide the capillary tube and thermocouple out of
the bracket and straighten the tube so that it can
be passed through the holes in the oven liner.
be passed through the holes in the oven liner.
7.
Remove the capillary tube from all routing clips.
8.
Carefully slide the capillary tube and
thermocouple through the holes in the oven.
9.
Remove the control valve, capillary tube, and
thermocouple from the unit.
10. Reverse the procedure to install a new control
valve assembly.
NOTE: During installation do not kink the new
capillary tube when feeding it through the holes in the
oven. Excess tubing can be loosely wrapped.
capillary tube when feeding it through the holes in the
oven. Excess tubing can be loosely wrapped.
OVEN PILOT ASSEMBLY
WARNING: DISCONNECT THE
ELECTRICAL POWER TO THE
MACHINE AND FOLLOW LOCKOUT /
TAGOUT PROCEDURES.
ELECTRICAL POWER TO THE
MACHINE AND FOLLOW LOCKOUT /
TAGOUT PROCEDURES.
WARNING: SHUT OFF THE GAS BEFORE
SERVICING THE UNIT.
SERVICING THE UNIT.
WARNING: ALL GAS JOINTS DISTURBED
DURING SERVICING MUST BE CHECKED FOR
LEAKS. CHECK WITH A SOAP AND WATER
SOLUTION (BUBBLES). DO NOT USE AN
OPEN FLAME.
DURING SERVICING MUST BE CHECKED FOR
LEAKS. CHECK WITH A SOAP AND WATER
SOLUTION (BUBBLES). DO NOT USE AN
OPEN FLAME.
The oven pilot assembly is attached to the burner
assembly behind the kick plate.
assembly behind the kick plate.
1.
Remove the kick plate as outlined under
COVERS AND PANELS.
2.
Remove the oven rack.
3.
Remove the oven bottom.
4.
Remove the oven left and right liner.
5.
Remove the oven bottom heat shield.
6.
Remove the screws securing oven pilot
assembly to the burner assembly.
7.
Pull the pilot assembly out through the front of
oven.
8.
Reverse the procedure to install the oven pilot
assembly.
OVEN BURNER ASSEMBLY
WARNING: DISCONNECT THE
ELECTRICAL POWER TO THE
MACHINE AND FOLLOW LOCKOUT /
TAGOUT PROCEDURES.
ELECTRICAL POWER TO THE
MACHINE AND FOLLOW LOCKOUT /
TAGOUT PROCEDURES.
WARNING: SHUT OFF THE GAS BEFORE
SERVICING THE UNIT.
SERVICING THE UNIT.
WARNING: ALL GAS JOINTS DISTURBED
DURING SERVICING MUST BE CHECKED FOR
LEAKS. CHECK WITH A SOAP AND WATER
SOLUTION (BUBBLES). DO NOT USE AN
OPEN FLAME.
DURING SERVICING MUST BE CHECKED FOR
LEAKS. CHECK WITH A SOAP AND WATER
SOLUTION (BUBBLES). DO NOT USE AN
OPEN FLAME.
The oven burner assembly is located behind the
kick plate.
kick plate.
1.
Remove the oven pilot assembly as outlined
under OVEN PILOT ASSEMBLY.