lift-master spswin 4.0 ユーザーズマニュアル
Entering and Editing Unit Data
Page 43 of 69
Doc 6001647, Rev B
I
NFINITY
(M
ULTI
-L
INK
)
You will need to enter settings for each unit in the chain.
1. Select the unit you wish to view.
2. Number of Digits in a Directory Code: Input
the number of digits used in directory codes
(usually 3).
(usually 3).
Note: Decreasing the number of directory or
entry code digits may make longer directory or
entry codes invalid. You will need to change
the longer directory/entry codes to fit the
shorter directory/entry code length.
entry code digits may make longer directory or
entry codes invalid. You will need to change
the longer directory/entry codes to fit the
shorter directory/entry code length.
3. Number of Digits in an Entry Code: Input
the number of digits used in entry codes
(usually 4).
(usually 4).
4. Cards = Codes: Enabling this Infinity and
Multi-Link function allows card numbers to be
used as entry codes.
used as entry codes.
5. Maximum Number of Keypad Errors: Sets
the number of keypad errors before the unit
stops accepting codes for 3 minutes and
closes a relay or places an alarm call if options
are enabled.
stops accepting codes for 3 minutes and
closes a relay or places an alarm call if options
are enabled.
6. Talk Time (in seconds): Input how long you
want a visitor to be able to talk to a tenant.
7. Auto-Prefix Long Distance Phone Numbers
With 1: Check this box if you must dial 1 to
make long distance telephone calls in your
area.
make long distance telephone calls in your
area.
8. Alarm Phone Number: If the unit has been
programmed to make an alarm call, the
telephone number is displayed. Otherwise,
“Alarm call disabled” is displayed.
telephone number is displayed. Otherwise,
“Alarm call disabled” is displayed.
Note: Alarm calling must be programmed at
the unit. See Programming Infinity Systems
with Multi-Link Firmware, document #
6001014.
the unit. See Programming Infinity Systems
with Multi-Link Firmware, document #
6001014.
9. Facility Code (Cards Only): Enter the 3-digit
facility code for this unit. If you don’t know the
facility code, enter “000”.
facility code, enter “000”.
10. Anti-Passback: Select either Disabled, Fully
Enabled, or Timed (and enter time in minutes).
11. PBX Digit: If calls to unit will go through a
PBX system, enter PBX prefix number.
12. Dialing Type: Select tone dialing unless pulse
is the only type available to you.
13. Answer Method: Multi-Link firmware uses the
Standard Answer Method.
Figure 50: Multi-Link Chain Definition Window Settings Page