Lowrance lmf-400 ユーザーズマニュアル
26
2. Highlight Change Units and press
ENTER
. Select
GPS
C
OORD
and
press
ENTER
to open the GPS Coordinates menu.
3. Select the desired option —
D
EG
/M
IN
or
D
EG
/M
IN
/S
EC
—
and press
ENTER
. The unit of measure has been changed to the option you
selected. You will be directed to the main display.
To change Volume units:
To change Volume units:
Choosing Volume from the Change Units menu will allow you to set the
unit of measure for volume to US Gallons or Liters.
1. Press
1. Press
MENU
, use the
UP
and
DOWN
keys to select
S
YSTEM
S
ETUP
and
press
ENTER
.
2. Highlight
C
HANGE
U
NITS
and press
ENTER
. Select
V
OLUME
and press
ENTER
to open the Volume menu.
3. Select the desired option —
US
G
ALLONS
or
L
ITERS
— and press
ENTER
.
The unit of measure has been changed to the option you selected. You
will be directed to the main display.
Fuel Setup
The following options may be accessed through the Fuel Setup menu:
Refill Tank, Partial Fill, Economy Speed Source, Fuel Remaining
Source, Reset Trip Fuel and Reset Seasonal Fuel.
Refill Tank
The Refill Tank command ensures the LMF-400 fuel reading is
Refill Tank
The Refill Tank command ensures the LMF-400 fuel reading is
consistent with the actual amount of fuel in your tank(s). The Refill
Tank command must be used with the EP-10 Fuel Flow, EP-50 Storage
Device and the Suzuki NMEA 2000 Engine Interface. The Refill Tank
command is NOT used when the EP-15 Fluid Level is used to read the
fuel level.
To refill tank:
To refill tank:
1. Press
MENU
, use the
UP
and
DOWN
keys to select
S
YSTEM
S
ETUP
and
press
ENTER
.
2. Highlight
F
UEL
S
ETUP
and press
ENTER
.
3. Select
R
EFILL
T
ANK
and press
ENTER
.
The
select Tank menu will
appear with up to three options (Port, Center and Starboard),
depending on the engine-tank configuration you chose during Boat
Setup. Select the tank you refilled and press
ENTER
. (If you have one
tank, you will be taken directly to the recalibration window mentioned
in step 4.)
NOTE:
NOTE:
If an EP-10 Fuel Flow or a Suzuki NMEA 2000 Engine Interface is
being used a menu will appear giving you the option to calibrate
fuel calculations. We will discuss calibration in Section 4:
Configuration and Calibration.