Lowrance lmf-400 ユーザーズマニュアル

48 

If you reset values from a fluid level menu, you will only restore 

default settings for that particular fluid level sensor. Executing the 

Reset Values command will also clear configuration and calibration 

settings. 

You can have up to three Suzuki Engine Interface's installed on your 

vessel, one for each engine the LMF-400 supports. In a three engine-

tank configuration, the interfaces will be listed as Port Engine, Center 

Engine and Stbd Engine. If the engine interface is unconfigured, it will 

be listed as Uncfg Eng Int. When accessing an Engine Interface, its 

menu will appear with the following options: Change Engine (for two or 

more engines only), Fuel Warning, Unset Engine, Reset Values, Reset 

Fuel Calibration and Reset Trim Calibration.  
NOTE: 

If, after configuring, unconfiguring or reconfiguring an engine 

interface, it is not shown on the Bus Devices list, you will have to 

refresh the list. Press 

, select

 and press 

. 

Highlight 

 and press 

. The Fuel Flow will be listed 

with its new configuration setting.  

To configure a Suzuki Engine Interface: 
1. Press 

, use the 

 and 

  keys  to  select 

 and 

press 

. 

2. Highlight 

 and press 

. The Bus Devices list will 

appear.  
3. Select 

 and press 

. The following message will 

appear: Press Enter to Configure Eng Intrfc. 
4. Press 

. The following list of Suzuki engine models will appear: 

DF40, DF50, DF60, DF70, DF90/115, DF140, DF150, DF175, 

DF200/225, DF250 and DF300. 
5. Select your engine model from the list and press 

. The Select 

Engine menu will appear with up to three options (Port, Center and 

Starboard), depending on your engine-tank configuration. If you chose 

a single engine configuration during Boat Setup, you will be taken back 

to the main display. 
6. Highlight the engine connected to your engine interface and press 

. If, for example, you select the Port, the following message will 

appear: Press ENTER to change to Port Engine.  
7. Press 

. You will be taken back to the main display.