dreamvision dl-500 ユーザーズマニュアル
10
4. Connecting a video source to the DreamVision DL500
The procedure for connecting a video
source to the DreamVision DL500 is
the same for S-video and Composite
video
source to the DreamVision DL500 is
the same for S-video and Composite
video
SECAM, PAL N and PAL M modes are manually
selected by pressing “Green Button“. If the right format
is not found first time, press again. The video format is
stored separately for each connector.
selected by pressing “Green Button“. If the right format
is not found first time, press again. The video format is
stored separately for each connector.
1.
Make sure that the video source and the
DreamVision DL500 are switched off.
DreamVision DL500 are switched off.
2.
Connect the video cable from the Video out
connector of the video source to the correct video
connector on the DreamVision DL500 plug panel.
connector of the video source to the correct video
connector on the DreamVision DL500 plug panel.
3.
Connect the audio cable from the Audio out
connectors of the video source to the Audio in
connectors on the DreamVision DL500. Connect
the red plug to the red connector, and the other
plug to the white connector. Red is the right stereo
channel.
connectors of the video source to the Audio in
connectors on the DreamVision DL500. Connect
the red plug to the red connector, and the other
plug to the white connector. Red is the right stereo
channel.
4.
When all the connections are done and verified,
switch on the video source and the DreamVision
DL500.
switch on the video source and the DreamVision
DL500.
5.
The DreamVision DL500 will now automatically
display the pictures from the video source. If not,
see the section ‘What do I do if’.
display the pictures from the video source. If not,
see the section ‘What do I do if’.
Figure 9:
Connecting to video sources
1183 (ELEK). LiteBeam ENG 15.10.98 14:16 Side 10