dreamvision dl-500 ユーザーズマニュアル

In order to use the DreamVision DL500 as a TV output;
connect the TV antenna to the TV connector on the
DreamVision DL500 plug panel. 

The DreamVision DL500 behaves just like a normal TV.
See the menus section 7.2.6 on how to adjust the TV
settings.

There are basically three ways of receiving the TV
signals to the DreamVision DL500:

◆

Antenna (Terrestrial)

◆

Cable 

◆

Set-up box for satellite  

These three work differently and it is important to
consider the options of each when adjusting the
DreamVision DL500 settings.

Antenna
When you adjust your TV to signals from an antenna
you must store each channel in a different program. .
The same is true for the DreamVision DL500 TV-tuner.
When connected to an antenna you assign the different
channels to the programs in the Television Setup Menu.
Then you use the Up and Down arrows 
in the menu, remote control or the channel up/down
button on the control panel to switch between channels.

Figure 11: Connecting to TV- source

1183 (ELEK). LiteBeam ENG  15.10.98  14:16  Side 12