iskratel si2000 callisto821 router ユーザーズマニュアル
SI2000 Callisto821+ Router Users Guide
96/107
• Use Subnet Configuration; there are two ways to specify a range of IP addresses. You can
either Use Subnet Mask (specify the subnet mask address of the IP address) or Use IP
Address Range (specify the first and last IP address in the range). Click on the drop-down
list and select a method.
Address Range (specify the first and last IP address in the range). Click on the drop-down
list and select a method.
• type in the IP Address that is visible outside the network
• Subnet Mask/IP Address 2; the value you specify here depends on the subnet configuration
that you are using. If you chose Use Subnet Mask, type in the subnet mask of the IP
address. If you chose Use IP Address Range, type in the last IP address in the range of
addresses that make up the global address pool.
address. If you chose Use IP Address Range, type in the last IP address in the range of
addresses that make up the global address pool.
4. Once you have configured the table, click on Add global address pool. The table is refreshed and the
global address pool is added to your NAT configuration.
... To delete a global address pool, click on the Delete hyperlink, then click on the Delete Global
Address Pool button.
These actions have the same effect as typing the following CLI commands:
Address Pool button.
These actions have the same effect as typing the following CLI commands:
nat add globalpool
nat list globalpools
nat delete globalpool
nat list globalpools
nat delete globalpool
Click on Return to Interface List to display the Security Interface Configuration page. To create a
reserved mapping, click on the Add Reserved Mapping hyperlink.
reserved mapping, click on the Add Reserved Mapping hyperlink.
8.2.3
NAT Reserved Mapping
Reserved mapping allows you to map an outside security interface or an IP address from a global pool to an
individual IP address inside the network. Mapping is based on transport type and port number. Before you
can configure reserved mapping, you need to configure NAT.
individual IP address inside the network. Mapping is based on transport type and port number. Before you
can configure reserved mapping, you need to configure NAT.
Configuring NAT reserved mapping
To set up a reserved mapping on your existing NAT enabled interfaces:
1. From
the
NAT Security Interfaces table, click on the Advanced NAT Configuration hyperlink for the
interface that you want to add reserved mapping to. The Advanced NAT Configuration page is
displayed.
displayed.
2. Click on the Add Reserved Mapping hyperlink. The following page is displayed: