opcode studio 4 ユーザーズマニュアル

You can create “MIDI stacks” by routing 
one input to more than one output. In 
Figure 7.18 one arrow routes the Master-
man-88 to the ProMaker/1 and the other 
routes the Masterman-88 to the Vectorific 
sound module. With this setup, the Mas-
terman-88 plays both synthesizers on the 
same MIDI channel transmitted by the 
Masterman-88. 

You can route your entire band through 
the Studio 4. Look at the MIDI routing in 
Figure 7.19 and notice that the Master-
man-88 plays the ProMaker/1, the 
GeoSkin drum pads control the Banger 
Man II drum machine, and the MIDI 
Tuba plays a Vectorific/Digiwhiz 2000 
MIDI stack.

There are two instances when it may not 
be desirable to define any MIDI routings:

•

When using a sequencing application
Most sequencers (such as Vision or 
Performer) control MIDI routing 
within the application. You use the 
sequencer to route MIDI inputs to 
MIDI outputs. Be aware that these 
routings can be active at the same 
time as routings established in the 
RCM window and, unless your care-
ful, could cause unwanted MIDI 
thruing and extra sounds.

•

When using an OMS patch
OMS patches (discussed in the 
Studio Patches Editor manual) allow 
you to design very advanced MIDI 
routing and processing paths using 
the Macintosh (instead of the 
Studio 4) to process MIDI data. Be