kvh 01027702bk install ユーザーズマニュアル

4.

With an assistant’s help, position the antenna
onto the centerline of the vehicle’s roof with a
mounting block and mounting plate under each
bracket. Make sure the antenna’s connector faces
the rear of the vehicle.

5.

The bottom of the antenna should rest above the
vehicle’s roof. If the antenna’s base is touching
the roof, you will need to add a spacer under
each bracket to raise the antenna higher. If
spacers are needed, STOP the installation. 
Call KVH at 401-847-3327 to order the Spacers
Kit (P/N 72-0221). Spacer installation
instructions are provided on page 2.10.

6.

Make sure the antenna is positioned on the
centerline of the roof in the desired location and
resting firmly on the mounting blocks. With the
antenna in place, mark the roof along the outside
edges of the mounting plates using a pencil or
scribe.   

7.

Set aside the antenna and the mounting blocks.

8.

Attach the four mounting plates to the roof at the
locations you outlined in Step 6. Be sure to use
fasteners appropriate to the roof’s construction.

9.

Seal all fasteners with silicone sealant or
equivalent.

10. Place the rubber mounting blocks back onto the

mounting plates.

11. Place the antenna onto the mounting blocks.

Align the holes in the antenna brackets with the
holes in the mounting blocks.

54-0350

Installing the Antenna

Bracket

Mounting Block

Due to the variation in RV roof construction,
consult with the RV manufacturer to
determine the safest fastening method.